ePRESS system

In full compliance with the regulations in force, EUROTIS presents the first and only patented press system for PLT-CSST corrugated tubes

The press fitting system summarizes the best traditions of reliability, flexibility and safety of Eurotis’ PLT-CSST corrugated tubes with the practicality and installation speed of the ePRESS Technology.

QUICK AND EASY TO INSTALL

It’s possible to manually bend the PLT-CSST tube without using other tools. This is possible thanks to the specific morphology of the corrugations and to a minimum thickness of 0.3 mm which give the tube the maximum performance during bending.

MAXIMUM SAFETY

The mechanical tightness consists of two pressing points.
1st point deforms the entrance of the fitting where there is a “tooth” which, after pressing, locks the tube and inserts itself in the last corrugation preventing it from slipping off.
2st pressing point deforms the gasket, allowing it to penetrate into the corrugations of the PLT-CSST tube and ensuring a secure and lasting seal.

UNIQUE AND PATENTED 

The ePRESS technology is entirely designed by Eurotis; this project led to the creation of a new jaw with “E” profile which allows a controlled deformation of the fitting and gasket ensuring the seal.
Moreover, thanks to the special “saddle”, the correct positioning of the fitting is guaranteed and the pressing is extremely simple and immediate, reducing the possibility of errors during installation.

Watch the video
assembly instructions

In full compliance with the regulations in force, EUROTIS srl presents the first patented press-fit system for corrugated pipes CSST

The ePRESS system summarizes the best traditions of reliability, flexibility and safety of the Eurotis CSST corrugated pipes with the practicality and speed of installation of the pressing system.

QUICK AND EASY TO INSTALL

It is possible to manually process and bend the PLT-CSST tube without using other tools. This is possible thanks to the specific morphology of the corrugations and to a minimum thickness of 0.3 mm which give the pipe the maximum performance during bending.

MAXIMUM SAFETY

The seal of the joint (pipe / fitting) is guaranteed by two pressing points.
1st point deforms the entrance of the fitting where there is a “tooth” which, after pressing, locks the tube and inserts itself in the last corrugation preventing it from slipping off.
2st pressing point deforms the gasket, allowing it to penetrate into the corrugations of the PLT-CSST tube and ensuring a secure and lasting seal.

UNIQUE AND PATENTED 

The pressing technique was entirely designed by Eurotis; this project led to the creation of a new jaw with “E” profile through which a controlled deformation of the fitting and of the gasket inside it is obtained, guaranteeing its tightness.
Moreover, thanks to the special “saddle”, the correct positioning of the fitting is guaranteed and the pressing is extremely simple and immediate, reducing the possibility of errors during installation.

Watch the video
assembly instructions

PRODUCTS

  • All
  • Press tools
  • Heat pumps press-fitting system
  • Solar press-fitting system
  • Water press-fitting system
  • Gas press-fitting system
<< back